How does MVHR work?

In the properties wet rooms (kitchens, bathrooms, W.C’s and utility rooms) extract points are installed to remove the warm, moist air and odours. Before this air has been extracted to outside, the recovered heat tempers the air passing into the building via a heat-exchange block within the unit. The fresh, filtered, pre-warmed air is supplied into the habitable rooms such as the bedrooms and living room. The heat exchanger can transfer up to 95% of the heat recovered into the fresh incoming air.

How are the ventilation rates calculated?

Typically, the minimum ventilation rate is calculated by multiplying the total internal floor area (m2) by 0.3. The boost rate is calculated by assigning the following vent rates to each wet-room, and then adding them together. (kitchen 13l/s, bathroom 8l/s, utility 8l/s, WC 6l/s)

What to do if my home gets too warm?

During the summer months, there can be a summer bypass option. This means that the intake air will not be tempered as it is diverted around the heat exchange block. This can help in reducing the indoor temperature. 

Can I leave my windows open?

MVHR units can run with the windows open, however this will make the unit less efficient during the winter months.

How will it work with my heating system?

MVHR systems are designed to ventilate your home; it does not actually heat your home. The two operate completely independently. However, the benefit is that you do not lose the heat you’ve paid to be generated like you would with a standard ventilation system, as the MVHR system will recover up to 95% of this heat energy.

Is much maintenance needed?

There is very little maintenance with our MVHR units. We recommend that you check your unit filters annually. The filters can either be cleaned or replaced. However, this will depend on the environment in which you live and how clean the air in your home is. 

How is the system controlled?

The minimum requirement for controlling the MVHR system would be to have a manual boost switch for each wet-room. The unit can also be controlled via humidistats and PIR sensors.

How long is the payback period?

The majority of Nuaire MVHR units have a payback period of 7-10 years. This can vary depending on factors such as environmental factors and airtightness of your home. Nuaire’s MVHR units run on an average of 15p per day.